An earlier example with an iconographic hilt.
Base 11 mm
Middle 5 mm
5 cm from tip 3 mm
Base 25.5 mm (narrow part)
Middle 30 mm
Widest 32 mm
15.5 cm from hilt
Iron, steel, silver, wood, ray-skin, cotton, lacquer
Burma, probably Yamethin district
From a German private collection
Anything similar for sale?
A dha (ဓား) of typical Burmese style and workmanship, as used and made by the dominant Bamar ethnic group.
It is not a piece without issues, so let's start there. It came to me in repaired condition: The round pommel cap, I believe is not original. It had no handle wrap, so Philip Tom did the ray-skin covering in traditional style. The wooden scabbard may be original, but with later silver wire wrapping, later baldric, and its halves held together with tape that was lacquered over.
Now on to the good part; The blade. Well-made and of nice proportions, it follows the typical Burmese form; Thick at the forte but with strong distal taper and gradually widening towards the tip. It has a long back-bevel running about three quarters of the blade.
In the center of the blade is a wide, shallow fuller that is entirely crosshatched and overlaid with silver after which the background was blackened to make the silver stand out. The designs are a very neat repeating scrollwork known in Burmese as chu-pan, executed by a skilled hand.
The back bevel is decorated by a dare I say lesser steady hand, with a double zig-zag pattern on the right side, and a single zig-zag pattern on the left. This pattern is also seen on the base of the spine.
The blade is made following the method described by Bell in 1907, being that of a steel jacket around a softer core.1 This is much like the kobuse construction of many Japanese swords. The jacket is wrapped around, but a subtle seem can be seen on the left side of the forte. The blade's edge also shows subtle signs of a heat treatment.
It appears to have seen some service, there are two cuts into the silver on the left side of the blade, and a small number of nicks with the typical shape of a nick caused by another edge.
Possible service damage; Cuts in the blade and some small edge nicks.
Dating & attribution
The only place I have found on record where ornate dha blades with silver overlay were created was Mindan, Yamethin district, just south of Mandalay.2 The work exhibited here is not the best produced in that town, but quality probably varied from maker to maker and from budget to budget. The owner also cut costs by going for a quite humble hilt and scabbard for this type. It was probably produced in the late 19th century.
1. E.N. Bell I.C.S.; A Monograph on Iron and Steel Work in Burma. Rangoon, Superintendent, Government Printing Burma, 1907.
2. See my glossary article: Mindan, Yamethin.
Do you have anything for sale?
I might be interested in buying it.Contact me
A rare set of twin knives in a single scabbard.
With intricately carved ivory hilt depicting a demon on a horse.
Made of a beautiful piece of black zitan hardwood, carved in a spiral, topped with a silver knob.
Plain when sheathed, unsheathing reveals a rather nice silver overlaid blade.
Presented by the local Dai nobility to a British customs officer in 1936.